The work site that is “connected” by IO-Link

IIO-Link is an open international standard communication technology used for sensors and actuators conforming to IEC61131-9.

By using IO-Link, even end-of-work site devices will possible to be networked, which information have been difficult to visualize up to now. In addition, due to the ease of use and the demand for IoT at work sites, the number of installations is increasing worldwide. The number of installations is expected to increase further in the future.

Notification of abnormalities in IO-Link devices. Can be controlled with reduced wiring!!

Anomalies of such as IO-Link compatible sensors are notified by LR6-IL / NE-IL through the IO-Link master. As a result, abnormalities at the work site can be detected at early stage and recover them. Reduce stop-losses and the improved operating rate is achieved. Further, it is connected to the IO-Link master by only M12 cable, and has just one power supply and control. With less wiring, it is possible to control more than conventional signal beacons.

USB bus power supply: control and power supply are well-connected with one USB cable

The LR6-USB type can be easily controlled by using the software library (download from our website). (Controls matching the protocol specifications are also possible on OSs other than the supported OSs.) Notifications are made for PC control devices such as the post-cash-register system and printers. This enables early recovery.

For further detailed information and other information display devices, please contact us using the form below!